Bomann GSPE 771.1 [19/31] Cleaning the door

The control panel can be cleaned by using a lightly dampened cloth.

After cleaning, make sure to dry it thoroughly.

For t he exterior, use a good appliance polish wax.

Never use sharp objects, scouring pads or harsh cleaners on a ny part of the dishwasher.

Protect Against Freezing

1.Cut off the electrical power to the dishwasher.

2.Turn off the water supply and disconnect the water inlet pipe from the water valve.

3.Drain the water from the inlet pipe an d water valve. (Use a pan to catch the water)

4.Reconnect the water inlet pipe to the water valve.

5.Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.

please take frost protection measures on the dishwasher in winter. Every fter washing cycles,

please operate as follows

time a

- Inspect the filters for blocking a fter e very time the dishwa sher has been used.

- By unscrewing the coarse filter, you can remove the filter system. Re move any foo d remnants and

clean the filters under running water.

Remarks:

Cleaning the Filter

Cleaning The Door

To clean the coarse filter and the fine filter, use a c leaning brush. Reassemble the filter p arts as show n in the figures

on the last page and reinsert the entire assembly in the dishwasher, positioning it in its seat and pressing dow nwards.

The entire filter assembly should be cleaned once a week.

When cleaning the filters, don't knock on them. Otherwise, the filters could be

contorted and the performance of the dishwasher could be decreased.

To clean the e dge around the door, you should use only a soft warm, damp cloth.

To avoid penetration of wa ter into the door lock and electrical components, do not

use a spray cleaner of any kind.

Never use a spray cleaner to clean the door panel as it may damage the door lock

and electrical components.

Abrasive agents or some paper towels shou ld not be used because of the risk of

scratching or leaving spots on the stainless steel surface.

Cleaning the Spray Arms

If your dishwasher cannot work because of the ice,

please contact professional service persons.

It is necessary to clean the spray arms regularly for hard

water chemicals will clog the sp ray arm jets and bearings.

To remove the spray arms, screw off the nut clockwise to

take out the washer on top of the spray arm and remove

the arm.

Wash the arms in soapy and warm water and use a soft

brush to c lean the jets. Replace them after rinsing them

thoroughly.