Bomann GSPE 771.1 [26/31] Extension hose

Positioning the Appliance

How to Drain Excess Water From Hoses

If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained dire ctly

into the sink. It wi ll be necessary to drain excess water from hoses into a bowl or suitable

container that is held outside and lower than the sink.

Water Outlet

Connect the water drain hose. The dra in hose must be correctly fitted to avoid water leaks.

Ensure that the water inlet hose is not kinked or squash ed.

Syphon Connection

Extension Hose

If you need a drain hose extension, make sure to use a similar drain hose.

It must be no longer than 4 metres; oth erwise the cleaning effect of the dishwasher could be reduced.

Position the appliance in the de sired location. The back shou ld rest against th e wall behind it, and the sides,

along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can

be positio ned either to the righ t or the left sides to facilitate proper installation.

The waste connection must be at a height of between 40 cm (minimum) and 100 cm (maximum)

from the botto m of the dish. The water drain hose should be fixed by a hose clip. The free end of

the hose must no t be immersed in water.

A hose that attaches to a sink spray can burst if it is installed on the same w ater line as the dishwasher. If your sink

has one, it is recommended that the hose be disconnected and the hole plu gged.

Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher.

Turn water fully on before starting the dishwasher.

Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.

The safety supp ly hose consists of the double walls. The hose's system guarantees its intervention b y block ing the

flow of water in case of the suppl y hose breaking and when the air space between the supply hose itself and the outer

corrugated hose is full of water.

Turn off the water.

Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the

room, from severe splashing.

Unscrew the safety supply hose from the faucet.

The appliance must be connected to the water mains using new hose-sets.

The old hose-sets should no t be reused.

Water pressure must b e between 0,04 MPa and 1 MPa. If the pressure is below the

minimum consult our Service Department for advice.

Connect the cold water supply hose to a threaded 3/4(inch) conn ector an d make sure that it is fastened tightly in place.

If the water pipes are new or have not been use d for an extended period of time, let the water run to make sure that the

water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked

and damage the appliance.