BLACK & DECKER KR5010 [5/24] Assembly
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

BLACK & DECKER KR5010 [5/24] Assembly

BLACK & DECKER KR5010 [5/24] Assembly
5
ENGLISH
(Original instructions)
Read
Instructions
Manual
Use Eye
Protection
Use Ear
Protection
V ........ Volts
A ........ Amperes
Hz .......
Hertz
W ........ Watts
min ..... minutes
..... Alternating
Current
..... Direct
Current
n
0
....... No-Load
Speed
...... Class II
Construction
.... Earthing
Terminal
.... Safety Alert
Symbol
.../min.. Revolutions
or Recipro-
cation per
minute
When assessing vibration exposure to
determine safety measures required by
2002/44/EC to protect persons regularly
using power tools in employment, an
estimation of vibration exposure should
consider, the actual conditions of use and
the way the tool is used, including taking
account of all parts of the operating cycle
such as the times when the tool is switched
o and when it is running idle in addition to
the trigger time.
Labels on tool
The label on your tool may include the
following symbols along with the date code:
Position of date barcode
The Date Code, which also includes the year
of manufacture, is printed into the housing.
Example:
2014 XX JN
Year of manufacturing
Electrical safety
Your tool is double insulated;
therefore no earth wire is required.
Always check that the main voltage
corresponds to the voltage on the
rating plate.
Warning! If the power cord is
damaged, it must be replaced by
the manufacturer, authorized
BLACK+DECKER Service Center or
an equally qualified person in order
to avoid damage or injury. If the
power cord is replaced by an
equally qualified person, but not
authorized by BLACK+DECKER, the
warranty will not be valid.
Features (Fig. A)
1. On/O switch
2. Lock-on button
3. Drilling mode selector
4. Chuck
Assembly
Warning! Before assembly, make sure that
the tool is switched o and unplugged.
Fitting a drill bit or screwdriver bit keyed
chuck (Fig. B)
• Open the chuck by turning the sleeve (5)
counterclockwise.
• Insert the bit shaft (6) into the chuck.
• Insert the chuck key (7) into each hole (8)
in the side of the chuck and turn
clockwise until tight.
Removing and refitting the chuck (Fig. C)
• Open the chuck as far as possible.
• Remove the chuck retaining screw,
located in the chuck, by turning it
clockwise using a screwdriver.
• Tighten an Allen key into the chuck and
strike it with a hammer as shown.
• Remove the Allen key.
• Remove the chuck by turning it
counterclockwise.
• To refit the chuck, screw it onto the
spindle and secure it with the chuck
retaining screw.
Use
Warning! Let the tool work at its own pace.
Do not overload.
Warning! Before drilling into walls, floors or
ceilings, check for the location of wiring and
pipes.
Selecting the direction of rotation
(Applicable for KR5010,KR5010V)
For drilling and for tightening screws, use
forward (clockwise) rotation. For loosening
screws or removing a jammed drill bit, use
reverse (counterclockwise) rotation.
• To select forward rotation, push the
Forward/Reverse slider to the centre
position.

Содержание

Похожие устройства

Скачать