Shimadzu UX-420H [88/129] Add on mode

14. Application Functions

Read Chapter 7 Before Use of These Pages

14.5 Add-on Mode

This function is convenient for weighing a large number of sample components as they are added on

the balance. Every time a component is added and stability is detected, the mass of it is displayed and

output through RS-232C or DATA I/O interface. The display will then be automatically zeroed for the

next component. When all the components have been weighed, the total mass is calculated by press-

ing [POWER] key.

Select menu item .

1 Load the weighing vessel and press the [O/T]

key in the Add-on standby state (The “Add-on”

and the Standby symbols are lit).

Zeroing occurs.

2 Press the [PRINT] key.

The Stand-by symbol disappears, and Add-on

measurement starts.

3 Load the first sample.

When stability is detected with a displayed value

five times the Zero Range or more, the displayed

value is automatically output and zeroing occurs.

Even if the displayed value is less than five times

the Zero Range, pressing [PRINT] key at stability

causes the same effect.

4 Repeat the above step 3 until all the compo-

nents have been weighed.

5 Press the [POWER] key.

The total sample mass on the pan is displayed

and the balance returns to the Add-on standby

state.

Press the [PRINT] key to output the total mass.

Start the next set of measurements from the

above step 1.