Home
Главная
Korg
Метроном
KDM-3 WWH Metronom Limited
Руководство по эксплуатации Страница: 4

Korg KDM-3 WWH Metronom Limited [4/8] Owner s manual

Thank you for purchasing the Korg KDM-3

DIGITAL METRONOME. To help you get

the most out of your new instrument,

please read this manual carefully.

Installing the Batteries

Open the battery cover, located on the

bottom of the KDM-3, and then insert the

batteries, making sure to observe the

correct polarity.

TIP

The settings are retained ev

en after the

KDM-3 is turned off. To return all settings

of the KDM-3 to their factory defaults, hold

down the TAP button and press the

STANDBY/ON button to turn on the

KDM-3.

Turning the Power on

Press the STANDBY/ON button to turn on

the power.

To turn off the KDM-3, hold down the

STANDBY/ON button until the display

goes off.

The power will automatically turn off if the

metronome has not been used for 20

minutes. (Auto power-off)

Connecting headphones

The KDM-3 can be used by connecting the

commercially-available stereo mini-plug

(φ3.5 mm) headphones to the PHONES

jack. When headphones are connected to

the KDM-3, no sound will be generated

from the speaker. The speaker or head

phones volume can be adjusted with the

Volume dial.

Metronome Mode

Turn the power on. The KDM-3 will enter the

metronome mode. Start or stop the metronome by

using the START/STOP button.

Specifying the tempo

Turn the TEMPO/CALIB dial to specify the tempo.

Specifying the tempo steps

Hold down the TIMER button to switch between

pendulum steps and full steps. When pendulum

steps are selected, “

” appears in the display.

Pendulum steps

The tempo can be set to one of 49 steps, representing

the tempo markings on a pendulum metronome.

TIP The value of each step is indicated on the side

of the KDM-3.

Full steps

The tempo can be increased or decreased in steps of

1 through the range of 30 to 252.

Specifying the tempo according to the tune

Press the TAP button several times in accordance

with the tempo of the tune to be played. The

metronome detects the interval at which you press

the switch, and specifies the tempo accordingly.

(Tap tempo)

TIP

If the detected tempo is lower than 30, it is specified

as 30, and if it is 252 or higher, it is specified as 252.

TIP During tap tempo input, “TAP” is displayed on

the display. If there is no input for a given period of

time, “TAP” disappears and tap tempo input ends.

Specifying the beat

Press the BEAT/NOTE  or  button to specify the

beat. “

” appears in the display in time with the

selected beat.

Specifying the metronome sound

Press the VOICE SELECT button to specify the

metronome sound.

Select a metronome sound between VOICE 1 and 8,

according to your instrument or requirements.

Mechanical metronome

Clap

PULSE (electronic)

Sticks

Cowbell

Rimshot

Claves

English voice (female)*

* Depending on the beat setting, the mechanical

metronome sound may be produced.

Specifying the timer

In timer mode, the metronome runs for the

specified time, then automatically stops.

1. Press the TIMER button to enter timer mode.

urn the TEMPO/CALIB dial (for 1-minute

steps) or press the BEAT/NOTE  or  button (for

10-second steps) to specify the amount of time that

the metronome will run. The time can be set within

the range of 1 to 120 minutes.

Press the ST

ART/STOP button to start the

metronome and timer countdown.

If the START/STOP button is pressed while the

timer and metronome are running in timer mode,

the timer is paused and the metronome is stopped.

TIP

To check the remaining amount of time during

operation, press the TIMER button. Pressing the

ART/STOP button while the timer is running will

pause the timer only. Press the TIMER button again

to end timer mode.

TIP

To return to the time you set, press the T

button while the timer is paused.

TIP

After reaching the last minute, the time display

switches from minutes to seconds.

4. When the specified time has elapsed, the

metronome automatically stops, and timer mode

ends.

Sound Out Mode

Press the SOUND button to enter the sound out

mode. A sound serving as a tuning guide will

generate. To return to metronome mode, press the

SOUND button in sound out mode.

Specifying the tone

Press the BEAT/NOTE  or  button to specify the

tone (note name). Tune the instrument using

the sound that is output (reference tone).

Reference pitch settings (calibration)

Turn the TEMPO/CALIB dial to adjust the

calibration value.

Specifications

Tempo range: 𝅘𝅥 = 30 to 252 beats/minute

Tempo setting:

PENDULUM step, FULL step

Beat range: 0 to 9 beats, duplets, triplets,

triplet with inner beat omitted, quadruplets,

quadruplets with inner beats omitted, son

clave (2-3) (3-2), rumba clave (2-3) (3-2)

Tempo accuracy: ±0.2%

Reference tone: C4 (261.63 Hz) to B4 (493.88

Hz) : 1 octave

Calibration range: A4=410 Hz to 480 Hz (unit:

1 Hz)

Reference tone precision: Within ±1 cent

Timer range: 1 to 120 minutes

Connector: PHONES jack (φ3.5 mm stereo

mini-jack)

Speaker: Dynamic speaker (φ36 mm)

Power supply: four AAA batteries

Battery life: Approx. 120 hours (120 tempo, 4

beats,

Mechanical metronome, maximum

volume, using alkaline batteries)

Dimensions (W x D x H):

60 mm x 73 mm x 113 mm / 2.36" x 2.87" x 4.45"

Weight: 167 g / 5.89 oz. (including batteries)

Included items: Owner’s Manual, four AAA

batteries

* The specifications and external appearance of this

product are subject to change without notice for

improvement.

Owner’s Manual

Korg KDM-3 WWH Metronom Limited [4/8] Owner s manual

Содержание

Похожие устройства