Home
Главная
Maxwell
Соковыжималка
MW-1105 ST
Инструкция по эксплуатации Страница: 8

Maxwell MW-1105 ST [8/40] English

ENGLISH

The unit is intended for household use only,

its commercial usage is prohibited.

BEFORE THE FIRST USE

After unit transportation or storage at low

temperature it is necessary to keep it for at

least two hours at room temperature before

switching on.

– Unpack the juice extractor.

Disassemble and clean the juice extractor

before usage:

• Remove the pusher (1) from feeding chute

(2) on the juice extractor lid (3).

• Lower the locking arm (7) and release the

lid (3).

• Remove the lid (3).

• It will be easier to remove the grating filter (4)

if you remove it with the juice collector (5),

holding the juice collector (5) and pulling it

upwards.

• Wash thoroughly and dry all the removable

parts that will contact food.

Note:

– Be cautious when holding grating filter

(4) in your hands, as disc grating surface

is very sharp.

MAKING JUICE

Before the first use make sure that the operat-

ing voltage of the unit corresponds to voltage of

your mains.

Fruit and vegetables should be fresh.

Before juice extracting wash fruit/vegetables

and cut them into pieces easily fitting into the

feeding chute (2), having removed inedible parts

from vegetables or fruit, such as stems, hard

peel or stones, for example, cherry or peach.

– Place the motor unit (8) on a dry, flat and

steady surface.

– Before assembling the juice extractor make

sure that the operation modes switch is set to

the position «0», and the plug is not inserted

into the socket.

– Attach the juice collector (5) to the motor

unit (8).

– Install the grating filter (4) inside the juice

collector (5).

Attention!

Do not use juice extractor if you found me-

chanical damages of grating filter (4).

– Install the lid (3) on the juice collector (5) and

fix it by placing the locking arm (7) in verti-

cal position.

– Install pulp container (10) to its place.

– Set the cup (11) under the juice draining

spout (6).

– Lower the juice draining spout (6) by press-

ing it (fig. 1).

– Insert the power plug into the socket.

– Switch the juice extractor on by setting the

switch (9) to the position «I» (low speed) or

to position «II» (high speed).

Note:

Low speed «I» is intended for extracting of juice

from soft vegetables/fruits – such as tomatoes,

ripe pears, strawberry, oranges, plums, grapes,

pumpkin, onion, cucumbers and etc.

High speed «II» is intended for extracting of

juice from hard vegetables/fruits – such as arti-

choke, carrots, apples, paprika, beet, potatoes,

pineapples, vegetable marrows, celery, spin-

ach, dill, leek etc.

Attention! To avoid the grating filter (4) stop-

ping and motor rotor jamming during the

processing of viscous or quite hard food it is

recommended to use the high speed opera-

tion mode «II» of the juice extractor.

– The unit will be switched on only if all the

removable parts are installed properly, and

the lid (3) is fixed with the locking arm (7).

– Feed the food into the feeding chute (2)

located on the lid (3) only when grating filter

(4) is rotating.

– Put the preliminary cut vegetables or fruits

gradually into the feeding chute (2) located

on the lid (3) and push them slightly with the

pusher (1). Do not press on the pusher (1)

too hard as it can lead to decrease of juice

amount and even to grating filter (4) rotation

stopping. The slower is the fruit and veg-

etables processing, the higher is the juice

extraction rate.

– Do not put your fingers or any other objects

into the feeding chute (2) located on the lid

(3).

– During the operation check the grating filter

(4) periodically for obstruction of mesh with

pulp, if necessary wash the grating filter (4);

before removing the grating filter switch the

juice extractor off and unplug it.

mw-1105.indd 8 11.03.2013 10:40:48

Maxwell MW-1105 ST [8/40] English

Содержание

Похожие устройства