Falmec Flipper 85 ix (800) ECP turquoise [18/64] Lighting

LIGHTING ASSEMBLY AND REPLACEMENT

1. LED SPOTLIGHT (Flipper)

In this case the hood is equipped with high efficiency, low power LED spotlights with

extremely high durability under normal use conditions. LED spotlight replacement should

only be carried out by qualified technicians using only original spare parts.

2. SPOTLIGHT (Flipper/E)

How to replace a square halogen light:

a) Check that the equipment is disconnected from the power supply.

b) Open the panel completely till 90° (see figure) pressing the PUSH button

c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 connection).

d) Close the panel. If the panel does not close correctly repeat the operation at point b.

MAINTENANCE AND CLEANING

Constant maintenance ensures the correct operation and efficiency of the appliance over

time. Special attention should be paid to the metal grease-trapping filters and the charcoal

filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do

not accumulate on the range hood, with the consequent risk of fire.

1. METAL ANTI-GREASE FILTERS

Their function is to trap suspended grease particles, accordingly, it is advisable to wash

them once a month in hot water and detergent, without bending them. Leave to dry

completely before re-assembling them.

2. CHARCOAL FILTERS

These trap the odours present in the stream of air that passes through them. The air is puri-

fied by passing a number of times through the filters and being recirculated into the kitchen.

The charcoal filters cannot be cleaned, and should be replaced on average every 3-4 months

(according to use). To replace the charcoal filters, see the instructions in point H2.

3. CLEANING THE OUTSIDE OF THE APPLIANCE

It is advised to clean the external hood surfaces at least every 15 days in order to avoid that

oily or greasy substances affect the steel surfaces.

The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid

detergent or denatured alcohol.

In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using

clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain

abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using

abrasive substances or rough cloths will inevitably damage the finish of steel. The steel

surface will be irrevocably damaged if the instructions above are not complied with. Keep

these instructions together with the instructions for use of your hood.

The manufacturer accepts no liability for any damage caused by non-compliance with the

instructions above.