Kramer VM-8HN [12/21] Loop 2 all leds flash slowly for a default edid

VM-8HN - Connecting the VM-8HN

Figure 3: Connecting the VM-8HN 1:8+2 HDMI Looping DA

5.1 Acquiring an EDID

To acquire an EDID, press the EDID SELECT button as follows:

1. The first press of the EDID SELECT button displays the present EDID status

similar to that shown in the next step.

2. The second press of EDID SELECT enters the read mode and each

additional press cycles through the source options:

OUT 1 -> OUT 2 -> OUT 3 -> OUT 4 -> OUT 5 -> OUT 6 -> OUT 7 -> OUT 8

-> LOOP 1 -> LOOP 2, all LEDS flash slowly for a default EDID.

3. When the desired EDID source is reached, press the EDID READ button.

The VM-8HN reads the EDID for a few seconds. When finished, all LEDS

return to display the present output connection status.

If an unconnected output is chosen or the EDID cannot be read, the VM-8HN loads the

default EDID.

Note: After reading an EDID, there is an interruption on the video outputs while syncing

with the monitors.

Note: The VM-8HN supports EDID Designer that can be downloaded from the Kramer

Web site at:

http://www.kramerelectronics.com/products/model.asp?pid=2826&pname=edid%20designer