Kramer TBUS-6xl [15/22] Inserting the tbus 6xl through the cut out opening

12 TBUS-6xl - Installing the TBUS-6xl

5.4 Inserting the TBUS-6xl through the Cut Out Opening

To install TBUS-6xl in the opening:

1. Remove the protective rubber guard from around the outer rim of the

TBUS-6xl housing. Beware of the sharp edge!

2. Carefully insert the unit into the prepared opening (see

Figure 5).

3. Take the support brackets under the table and place them into the support

bracket grooves on both sides of the unit (see

Figure 1).

4. Verify proper alignment of the unit before tightening the mounting screws.

5. Tighten both mounting butterfly screws upward until they reach the table

surface (from underneath). Tighten firmly (see

Figure 5).

6. Tighten the locking butterfly screws downward until tight against the

mounting bracket.

Figure 5: Inserting TBUS-6xl into the Prepared Opening