Kaiser HC 60040N [8/76] Preparation

INSTALLATION

Before using your new appliance, make sure to fit

it properly. By fixing the adjustable feet in a proper

position, you can keep the upper surface strictly

horizontally and, thus, avoid backlash. For this

purpose, take out the drawer at the bottom.

The cooker is intended to be build up into kitchen

furniture, however, only up to the height of the

working plate, i.e. fixing up higher than 850 mm

from the floor level is unreasonable.

All materials used for furniture panels should be

heat resistant at the temperature 100°C minimum.

Breach of this regulation can result in distortion or

ungluing of panel coverings. To avoid heat

distortion of the furniture panels, ensure that the

space between the contact surfaces is not less

than 2 cm.

Please mount the fume extractor hood at about

600-700 mm above the cooking surface (see

installation instructions for your fume extractor

hood).

PREPARATION

Clean the oven thoroughly with soapy water and

rinse well. Fit schelf support side rails and place in

wire shelves and backing trays.

Operate the oven for about 30 minutes at

maximum temperature to burn off all traces of

grease which might otherwise create unpleasant

smells when cooking.

Important !!!

Safety precaution: before cleaning the oven,

disconnect the plug from the electrical outlet or the

power cable from the oven. Do not use acid or

alkaline substances to clean the oven (lemon juice,

vinegar, salt, tomatoes etc.). Do not use chlorine

based products, acids or abrasive products to

clean the painted surfaces of the oven.

Attention! Set the time on the clock before

you can use the oven.

(See chapter „Electronic programmable

control“).

If the time is not set, the oven cannot be

operated.