Moxa CP-132S [22/45] Port configuration stage

CP-132 Series Software Installation

3-10

Port Configuration Stage

After the driver is installed, CP-132 Series Installation dialog box will be displayed automatically and the port

mapping is automatically done by the system.

If one CP-132 Series board had installed previously and another CP-132 Series board was plugged, the system

will prompt you to do port configuration directly discussed in this section.

1. Click on a specific port.

2. Click [Port Setting] button to open Port X dialog box.

3. Select a COM number for the specific port from Port Number pull-down list.

NOTE

Step 4 is optional, if you want to assign COM numbers to Ports manually.

4. Check Auto Enumerating COM Number check-box then the subsequent ports are mapped to continuous

COM numbers. For example, if COM 3 is assigned to Port 1, then COM 4 will be automatically assigned to

Port 2.

NOTE

You may skip Step 5 to 8, if the system doesn’t require a special performance tuning.

5. Select an Rx FIFO Trigger from Rx FIFO Trigger pull-down list.

Rx FIFO trigger levels, at 1, 4, 8 or 14 bytes, are available, and the default value is 14 bytes.

6. Check Set the change to all ports check-box then if desire to apply Rx FIFO Trigger just defined to all ports.

7. Select a Tx FIFO Size from Tx FIFO Size pull-down list.

Tx FIFO sizes from 1 to 16 bytes are available, and the default value is 16 bytes.