Moxa DA-682A-C7-W7E [22/42] Upgrading the memory module

DA-682A Series Hardware Hardware Installation

2-10

Upgrading the Memory Module

The DA-682A embedded computer supports one DDR3 1066/1333 SODIMM module, up to 4 GB. One DDR3

SDRAM memory module is installed at the factory. To upgrade the SDRAM memory module, follow these

instructions:

1. Disconnect the DA-682A from its power source.

2. Unfasten the screws on the back of the computer, and then take off the upper cover.

3. Find the location of the SDRAM memory socket.

4. Push two clutches of the socket, and remove the old memory module. Insert the new memory module into

the socket, and make sure you insert the SDRAM in the correct direction. Push down the memory module

and make sure that the clutches have been securely fasten.

5. When finished, replace the upper cover of the computer and fasten the screws.

Installing a CompactFlash Card

The DA-682A embedded computer comes with a CompactFlash socket. To insert a CompactFlash card, follow

these instructions.

1. Disconnect the DA-682A from its power source.