Autel Autolink AL319 [24/47] Led lamps not working

Scan tool doesn’t power up

If the scan tool won‟t power up or operates incorrectly in any other

way, you need to do the following to check up:

 Check if the scan tool‟s OBD II connector is securely connected

to the vehicle‟s DLC;

 Check if the DLC pins are bent or broken. Clean the DLC pins if

necessary.

 Check vehicle battery to make sure it is still good with at least 8.0

volts.

LED lamps not working

If you turn on the scan tool and perform the I/M Readiness test but

the LED lamps are not working, there may be several possible causes,

including bad connection and ignition off. In this case, follow these

steps to check the scan tool.

 Make sure the OBD II cable is connected to the DLC securely.

 Verify the ignition key is in the KOER position.

 Run the LED Test in the System Setup menu. (see 3.7 System

Setup). If the scan tool did not pass this test, there is a problem

with the LED lamp. Please contact Autel Tech Support or your

local selling agent.