Autel Autolink AL319 [44/47] As pre check diagnostic tool

2) After the erase procedure is performed, status of most monitors

will be changed. Leave the scan tool connected to the vehicle,

and select Ready Test from Main Screen.

3) Keep on driving the car till the scan tool notifies you safely with

color LEDs and audible tone that the drive cycle has been

completed and the vehicle is ready, eliminating drive cycle

guesswork and confirming readiness status.

4) If the GREEN LED lights and two long beeps are heard, your

vehicle is ready and the repair work is confirmed.

5) If the RED LED lights, your vehicle is not ready and the repair

work is unsuccessful.

As pre-check diagnostic tool

Prior to having a vehicle inspected for compliance to a state

emissions test, you could use this function to check the readiness

status first by yourself.

1) While the scan tool connected to the vehicle, select Ready Test

from Main Screen. Drive the car till the scan tool notifies you

safely with color LEDs and audible tone if your vehicle is ready

to conduct state emission test.

2) If the GREEN LED lights and two long beeps are heard, your

vehicle is ready and there is a good possibility that it can be

certified.

3) If the RED LED lights, your vehicle is not ready and must be

repaired before an emissions test can be performed.

IMPORTANT: If you are driving the vehicle to perform a drive

cycle ALONE, please set the Status Beep On (see 3.7 System Setup).

By listening to the beep, you will learn when the monitors have run

and completed the diagnostic testing. NEVER try to drive and

operate the scan tool at the same time!