Autel Autolink AL319 [45/47] Led and tone interpretation

NOTE: This function reads off the real time data of

emission-related monitoring systems readiness status. Once the scan

tool has finished other operations, for example, clearing trouble

codes, the I/M Readiness Monitor Status program resets status of all

the monitors to “INC” condition. In order to set these monitors to a

Ready status, the vehicle must be driven through a complete drive

cycle. Times for reset vary depending on vehicle. Please refer to

your vehicle’s service manual for drive cycle information.

NOTE: In this function, only ENTER/Exit button is available. The

other buttons are disabled to prevent misoperation.

5.3 LED and Tone Interpretation

Select Ready Test from the Main Screen and the screen shows as

below, including applicable monitors status, MIL state, Ignition type,

DTCs (stored one and pending one).

Figure 5.2

If the scan tool is idle, it will show the result immediately. If it is busy,

it will wait till the current procedure finished. After viewing the status,

press ENTER/Exit button to exit.

“OK” -- Indicates that a particular monitor being checked

has completed its diagnostic testing.

“INC” -- Indicates that a particular monitor being checked

has not completed its diagnostic testing.