Netgear R6300 [106/127] Sequence to restart your network

Troubleshooting

106

R6300 WiFi Router 802.11ac Dual Band Gigabit

Quick Tips

This section describes tips for troubleshooting some common problems

Sequence to Restart Your Network

Be sure to restart your network in this sequence:

1. T

urn off and unplug the modem.

2. T

urn off the router and computers.

3. Plug in the modem and turn it on. W

ait 2 minutes.

4. T

urn on the router and wait 2 minutes.

5. T

urn on the computers.

Check Ethernet Cable Connections

Make sure that the Ethernet cables are securely plugged in.

• The Internet LED on the router is on if the Ethernet cable connecting the router and the

modem is plugged in securely and the modem and router are turned on.

• For each powered-on computer connected to the router by an Ethernet cable, the

corresponding numbered router LAN port LED is on.

Wireless Settings

Make sure that the wireless settings in the computer and router match exactly.

• For a wirelessly connected computer

, the wireless network name (SSID) and wireless

security settings of the router and wireless computer need to match exactly.

• If you set up an access list in the

Advanced Wireless Settings screen, you have to add

each wireless computer’s MAC address to the router’s access list.

Network Settings

Make sure that the network settings of the computer are correct.

• Wired and wirelessly connected computers need to have network (IP) addresses on the

same network as the router.

The simplest way to do this is to configure each computer to

obtain an IP address automatically using DHCP.

• Some cable modem service providers require you to use the MAC address of the

computer initially registered on the account.

You can view the MAC address in the

Attached Devices screen.