Tp-Link T2700G-28TQ [16/36] Installing removing the interface card optional

Stackable L2+/L3 Managed Switch

2. If the protective cover has been installed on the power supply module slot of the

switch, use a Phillips screwdriver to loosen the mounting screws of the protective

cover and remove the protective cover, as shown in the following figure.

Figure 3-4 Removing the Protective Cover

3. Grip the handle of the module by one hand, and hold the bottom of the module by

the other hand, as shown in the following figure. Then gently push the module in

along the slot guide rail until the module is flush with the switch.

Note:

Do not use too much force in the operation. If resistance is encountered or

positions of the power supply module appear larger deflection in the operation of

installation, you must first remove the module and then reinstall the module.

Switch

PSM150-AC

Power

PS OK

Fault

Figure 3-5 Installing the Power Supply Module

4. Tighten the captive screws with a Phillips screwdriver to fix the power supply module

in place. If the screws cannot be tighten, probably because the power supply module

is not installed properly due. Please check carefully.

3.4 Installing & Removing the Interface Card (Optional)

■

Installing the Interface Card

1. Wear an ESD-preventive wrist strap, and make sure that it has good skin contact and

is well grounded.

2. Use a Phillips screwdriver to loosen the mounting screws of the protective cover on

the interface card slot of the switch and remove the protective cover, similar to the

procedure shown in Figure 3-4.

Installation