Gorenje BHP643ORAB [30/100] Ducting version

EN30

The symbol on the product, or on the documents accompanying the product, indicates that this

appliance may not be treated as household waste. Instead it should be taken to the appropriate

collection point for the recycling of electrical and electronic equipment. Disposal must be carried

out in accordance with local environmental regulations for waste disposal.

For further detailed information regarding the process, collection and recycling of this product, please

contact the appropriate department of your local authorities or the local department for household waste

or the shop where you purchased this product.

Appliance designed, tested and manufactured according to:

Increase the speed only in case of large amount of smoke and vapour and use boost speed(s) only in

extreme situations. Replace the charcoal filter(s) when necessary to maintain a good odour reduction

noise.

Additional Installation Specifications:

correct screws type. Use the correct length for the screws which are identified in the Installation Guide.

In case of doubt, consult an authorised service assistance centre or similar qualified person.

WARNING! Failure to install the screws or fixing device in accordance with these instructions may result

Attention! The exhausting pipe is not supplied and must be purchased apart. Diameter of the exhausting

pipe must be equal to that of the connection ring.

In the horizontal runs the exhausting pipe must be slightly slanted (about 10°) and directed upwards to

vent the air easily from the room to the outside.

Attention! If the hood is supplied with active charcoal filter, then it must be removed.

Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet (connection

flange).

Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the

suction performance and a drastic increase in noise.

Any responsibility in the matter is therefore declined.