Gorenje BHP643ORAB [33/100] Charcoal filte

EN33

Setting of Automatic Operation parameters

For correct use of the automatic operation, perform “Hood Calibration”.

Hood Calibration

With the display on (ON) and the suction o (OFF), press button T3 for 5 seconds.

The suction speed (power) 1 starts functioning and button T3 ﬂashes to indicate that hood calibration is

initiated and it will last for approx. 5 minutes.

Note: to interrupt the calibration, press T3 for 5 seconds; the calibration will be invalidated and should

therefore be repeated.

MAINTENANCE

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical

supply by switching o at the connector and removing the connector fuse.

Or if the appliance has been connected through a plug and socket, then the plug must be removed

from the socket.

CLEANING

The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out

maintenance of the fat ﬁlters) internally and externally. Clean using the cloth dampened with neutral liquid

detergent. Do not use abrasive products. DO NOT USE ALCOHOL!

WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and

replacement of the ﬁlters may cause ﬁre risks. Therefore, we recommend observing these instructions.

The manufacturer declines all responsibility for any damage to the motor or any ﬁre damage linked to

inappropriate maintenance or failure to observe the above safety recommendations.

GREASE FILTER

Traps cooking grease particles. The grease ﬁlter must be cleaned once a month using non aggressive

detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle.

When washed in a dishwasher, the grease ﬁlter may discolour slightly, but this does not aect its ﬁltering

capacity. To remove the grease ﬁlter, press it and pull it down.

CHARCOAL FILTER (ﬁlter version only)

It absorbs unpleasant odours caused by cooking. The saturation of the charcoal ﬁlter occurs after more or

less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease ﬁlter.

In any case it is necessary to replace the cartridge at least every four mounths. The charcoal ﬁlter may

NOT be washed or regenerated.

REPLACING LAMPS

The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an optimum

lighting, a duration up to 10 times as long as the traditional lamps and allow to save 90% electrical energy.

For replacement, contact the technical service.