Falmec Mimosa 90 (600) S — установка и эксплуатация вытяжного устройства: важные рекомендации [16/68]

Do notflambe under the rangehood The exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels Ensure that all regulations concerning the discharge of exhaust air have been fulfilled before you use the appliance Before performing any cleaning or maintenance operations disconnect the appliance by un plugging it or using the main switch The manufacturer disclaims all liability for any damage that may be directly or indirectly caused to people things and animals due to the failure to follow all the instructions provided in this booklet and above all the warnings relating to the installation operation and maintenance of the appliance there is a fire risk if cleaning is not carried out in accordance with the instructions CAUTION Accessible parts may become hot when used with cooking appliances Max length screw for fixing the chimney is 10 mm provided by the manufacturer WARNING Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards Warning only for Australia hood width less than 90 cm use max 4 hobs BJ TECHNICAL SPECIFICATIONS The technical data pertaining to the electric appliance The technical specifications of the ap pliance are shown on the rating plates located inside the range hood C INSTALLATION Section reserved for qualified installers of the range hood The distance between the hob and the lowest part of the rangehood is normally at least 65 cm see figure C1 This distance is measuresd in the lowest part of the rangehood not operating at safety voltage Based on this detail provided by European Standards the distance may be reduced in some models as specified in the general catalogue If the instructions for installa tion for the gas hob specify a greater distance this has to be taken into account In the outside exhaust version the diameter of the fume discharge duct must be no smaller than the range hood connection In the horizontal sections the duct must slope slightly around 10 upwards so as to better convey the air outside of the room Avoid using angled pipes make sure that the pipes are at least of the minimum length Comply with the current regulations on air discharge into the atmosphere If a boiler stove fireplace etc that uses gas or other fuels is being used at the same time make sure the room where the fumes are extracted is well ventilated in compliance with the current regulations Mounting instruction see section 0 of the booklet DJ ELECTRICAL CONNECTIONS Section reserved for qualified installers WARNING Before doing any work inside the range hood disconnect the appliance from the mains power supply Check that the wires inside the range hood are not disconnected or cut if this is the case contact your nearest service centre The electrical connections must be performed by quali fied personnel The connections must be performed in compliance with the legal standards in force Check 14