Victoria Arduino Adonis 2 Gr белая [85/136] Press up or down to move up and down the working point

Pressure calibration: -200 - 0 - +200 mbars

(WV UP/DOWN to switch).

Pre brewing: not active - active

(WV UP/DOWN to switch).

Cup warmer: single - single temp. - double temp.

(WV UP/DOWN to switch).

Clock calibration: -300 - 0 - +300 sec/month

(WV UP/DOWN to switch).

Serial connection: active - not active

(WV UP/DOWN to switch).

Least group: 0 - 1 - 2 - 3 (WV UP/DOWN to switch).

Least serve: 0 - 1 - 2 - 3 (WV UP/DOWN to switch).

DIRECT LINKS

In "machine ready" state you can go direct to the settings

below instead of surfing the menu.

SETTING THE TEMPERATURE POINT:

Press ENTER + V to go directly to the Setting Point

menu (this will be bars or °C/°F depend on the status

view you were).

WV

press UP or DOWN to move up and down

the working Point.

Press ENTER to confirm and pass to the next step.

MONITORING UNIT (°C/°F - BAR)

The display can also show you the pressure or tempera-

ture status of the boiler; to pass from one to the other,

press the W key on the display.

In the case of pressure, the reading will be shown in bar,

while for temperature, it will be in degrees Celsius (°C)

or Fahrenheit (°F). The display setting for the tempera-

ture can be chosen from the setpoint setting page. In

fact, when choosing the temperature mode, the setpoint

will be shown in degrees Celsius or Fahrenheit accord-

ing to the chosen measurement.

ON OFF STAND-BY

(ENERGY SAVING MODE)

This allows to rotate into the three working modes/sta-

tuses.

Press RESET for 3 sec to switch on Æoff Æstand-

by the machine status.