Hitachi G23MRU-NB [7/49] English

6

English

SPECIFICATIONS

*1 Be sure to check the nameplate on product as it is subject to change by areas.

*2 Weight: Only main body

*3 The starting current limiter produces the starting current to such an extent that a fuse (16 A, slow-blow)

is not tripped.

STANDARD ACCESSORIES

(1) Wrench ........................................................................1

䡬

Removal of casting fin and finishing of various types

of steel, bronze and aluminum materials and castings.

䡬 Grinding of welded sections or sections cut by

䡬 Grinding of synthetic resins, slate, brick, marble, etc.

䡬 Cutting of synthetic concrete, stone, brick, marble

will start operating immediately, which could cause

a serious accident.

When the work area is removed from the power

source, use an extension cord of sufficient thickness

䡬 Then, turn the wheel guard to a desired position

(for use).

䡬 Close the lever and fix it. If and when required,

carry out adjustments by tightening or loosening

䡬 If the lever does not move smoothly, apply some

lubricating oil to the sliding section between the set

䡬 Fasten the wheel guard at the position where the

Wheel Assembly”.

6. Conducting a trial run

Ensure that the abrasive products is correctly

mounted and tightened before use and run the tool

at no-load for 30 seconds in a safe position, stop

immediately if there is considerable vibration or if

other defects are detected.

If this condition occurs, check the machine to

PRACTICAL GRINDER APPLICATION

1. Pressure

Model G18MR G18MRU G23MR G23MRU

(110V, 220V, 230V, 240V)

Wheel Hole dia. 22 mm

2

5.4 kg

Starting current limiter*

3

No Yes No Yes