Hotpoint-Ariston C 35S P6 R/HA [20/76] Start up and use

Hotpoint-Ariston C 35S P6 R/HA [20/76] Start up and use
20
GB
Start-up and use
Using the hob
Lighting the burners
For each BURNER knob there is a full ring showing the
strength of the flame for the relevant burner.
To light one of the burners on the hob:
1. Bring a flame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an
anticlockwise direction so that it is pointing to the
maximum flame setting E.
3. Adjust the intensity of the flame to the desired level
by turning the BURNER knob in an anticlockwise
direction. This may be the minimum setting C, the
maximum setting E or any position in between the two.
If the appliance is fitted with an
electronic lighting device* (see
figure), press the BURNER
knob and turn it in an
anticlockwise direction,
towards the minimum flame
setting, until the burner is lit.
The burner may be
extinguished when the knob is released. If this occurs,
repeat the operation, holding the knob down for a
longer period of time.
If the flame is accidentally extinguished, switch off
the burner and wait for at least 1 minute before
attempting to relight it.
If the appliance is equipped with a flame failure safety
device*, press and hold the BURNER knob for
approximately 2-3 seconds to keep the flame alight
and to activate the device.
To switch the burner off, turn the knob until it reaches
the stop position .
Practical advice on using the burners
For the burners to work in the most efficient way
possible and to save on the amount of gas consumed,
it is recommended that only pans that have a lid and a
flat base are used. They should also be suited to the
size of the burner:
Burner ø Cookware diameter (cm)
Triple Crown (TC) 24 - 26
Semi Fast (S) 16 - 20
Auxiliary (A) 10 - 14
Using the oven
The first time you use your appliance, heat the empty
oven with its door closed at its maximum temperature
for at least half an hour. Ensure that the room is well
ventilated before switching the oven off and opening
the oven door. The appliance may emit a slightly
unpleasant odour caused by protective substances
used during the manufacturing process burning away.
Never put objects directly on the bottom of the oven;
this will avoid the enamel coating being damaged.
Before operating the product, remove all plastic film
from the sides of the appliance.
1. Select the desired cooking mode by turning the
SELECTOR knob.
2. Select the recommended temperature for the
cooking mode or the desired temperature by turning
the THERMOSTAT knob.
A list detailing cooking modes and suggested cooking
temperatures can be found in the relevant table (see
Oven cooking advice table).
During cooking it is always possible to:
Change the cooking mode by turning the
SELECTOR knob.
Change the temperature by turning the
THERMOSTAT knob.
Stop cooking by turning the SELECTOR knob to the
0 position.
Always place cookware on the rack(s) provided.
THERMOSTAT indicator light
When this is illuminated, the oven is generating heat. It
switches off when the inside of the oven reaches the
selected temperature. At this point the light illuminates
and switches off alternately, indicating that the
thermostat is working and is maintaining the
temperature at a constant level.
Oven light
This is switched on by turning the SELECTOR knob to
any position other than 0. It remains lit as long as the
oven is operating. By selecting
8
with the knob, the
light is switched on without any of the heating
elements being activated.
*
Only available in certain models.

Содержание

Start up and use GB Using the hob Using the oven Lighting the burners The first time you use your appliance heat the empty oven with its door closed at its maximum temperature for at least half an hour Ensure that the room is well ventilated before switching the oven off and opening the oven door The appliance may emit a slightly unpleasant odour caused by protective substances used during the manufacturing process burning away For each BURNER knob there is a full ring showing the strength of the flame for the relevant burner To light one of the burners on the hob 1 Bring a flame or gas lighter close to the burner 2 Press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting A 3 Adjust the intensity of the flame to the desired level by turning the BURNER knob in an anticlockwise direction This may be the minimum setting 6 the maximum setting 6 or any position in between the two If the appliance is fitted with an electronic lighting device see figure press the BURNER knob and turn it in an anticlockwise direction towards the minimum flame setting until the burner is lit The burner may be extinguished when the knob is released If this occurs repeat the operation holding the knob down for a longer period of time If the flame is accidentally extinguished switch off the burner and wait for at least 1 minute before attempting to relight it If the appliance is equipped with a flame failure safety device press and hold the BURNER knob for approximately 2 3 seconds to keep the flame alight and to activate the device Never put objects directly on the bottom of the oven this will avoid the enamel coating being damaged Before operating the product remove all plastic film from the sides of the appliance 1 Select the desired cooking mode by turning the SELECTOR knob 2 Select the recommended temperature for the cooking mode or the desired temperature by turning the THERMOSTAT knob A list detailing cooking modes and suggested cooking temperatures can be found in the relevant table see Oven cooking advice table During cooking it is always possible to Change the cooking mode by turning the SELECTOR knob Change the temperature by turning the THERMOSTAT knob Stop cooking by turning the SELECTOR knob to the 0 position Always place cookware on the rack s provided THERMOSTAT indicator light To switch the burner off turn the knob until it reaches the stop position Practical advice on using the burners For the burners to work in the most efficient way possible and to save on the amount of gas consumed it is recommended that only pans that have a lid and a flat base are used They should also be suited to the size of the burner Burner e Cookware diameter cm Triple Crown TC 24 26 Semi Fast S 16 20 Auxiliary A 10 14 When this is illuminated the oven is generating heat It switches off when the inside of the oven reaches the selected temperature At this point the light illuminates and switches off alternately indicating that the thermostat is working and is maintaining the temperature at a constant level Oven light This is switched on by turning the SELECTOR knob to any position other than 0 It remains lit as long as the oven is operating By selecting A with the knob the light is switched on without any of the heating elements being activated Only available in certain models 20