Trotec Speedy 300 [11/60] General safety information

8011 Trotec Speedy 300

SAFETY

28/07/2015 Trotec Laser GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support 11 / 60

tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto: techsupport@troteclaser.com

2 SAFETY

2.1 General Safety Information

All personnel involved in installation, set-up, operation maintenance and repair of the machine,

must have read and understood the Operation Manual and in particular the "Safety" section. The

user is recommended to generate company-internal instructions considering the professional

qualifications of the personnel employed in each case, and the receipt of the instruction/Operation

Manual or the participation at introduction/training should be acknowledged in writing in each case.

Safety-conscious Working

The machine must only be operated by trained and authorized personnel.

The scopes of competence for the different activities in the scope of operating the machine must

be clearly defined and observed, so that under the aspect of safety no unclear questions of

competence occur. This applies in particular to activities on the electric equipment, which must

only be performed by special experts.

For all activities concerning installation, set-up, start-up, operation, modifications of conditions and

methods of operation, maintenance, inspection and repair, the switch-off procedures that may be

provided in the Operation Manual must be observed.

Safety Information for the User and/or Operating Personnel

 No working methods are permitted that affect the safety of the machine.

 The operator must also ensure that no unauthorized persons work with the machine (e.g. by

activating equipment without authorization).

 It is the duty of the operator, to check the machine before start of work for externally visible

damage and defects, and to immediately report changes that appear (including behavior during

operation) that affect the safety.

 The user must provide that the machine is only operated in perfect condition.

 The user must guarantee the cleanness and accessibility at and around the machine by

corresponding instructions and controls.

 Principally, no safety components may be removed or disabled (already here we emphasize the

imminent dangers, for example severe burns, loss of eye-sight). If the removal of safety

components is required during repair and service, the replacement of the safety components

must be performed immediately after completion of the service and repair activities.