Trotec Speedy 300 [6/60] Designated use

8011 Trotec Speedy 300

GENERAL

28/07/2015 Trotec Laser GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support 6 / 60

tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto: techsupport@troteclaser.com

1.2 Designated Use

The Trotec Speedy 300, is used for engraving and cutting of signs, stamps and suchlike.

A wide variety of materials such as rubber, acrylic, coated metal, tin, special steel,

anodized aluminum, cork, cardboard, glass, leather, marble, several plastics and wood

can be processed on the laser.

The engraving process must only be performed with a perfectly adjusted

machine (see also Section 4 OPERATION).

For cutting applications with 45 W and more the use of the cutting table is

absolutely necessary.

Use of the system in other areas is against the designated use. The

manufacturer does not admit liability for damage to personal and/or

equipment resulting from such use.

The system must only be operated, maintained and repaired, by personnel

that are familiar with the designated field of use and the dangers of the

machine!

Non-observance of the instructions for operation, maintenance and repair

described in this Operation Manual excludes any liability of the manufacturer

if a defect occurs.

Caution when processing conductive materials (carbon fibers,…)! Conductive

dust or particles in the ambient air might damage electrical components and

lead to short circuits. Bear in mind that those defects are NOT warranted.

1.3 Disposal remarks

Do not dispose the machine with domestic waste!

Electronic devices have to be disposed according to the regional directives

on electronic and electric waste disposal.

In case of further questions, please ask your supplier. He might take care of

proper disposal.