Trotec Speedy 300 [21/60] Exhaust system requirements

8011 Trotec Speedy 300

BEFORE OPERATION

28/07/2015 Trotec Laser GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support 21 / 60

tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto: techsupport@troteclaser.com

3.5 Exhaust System – Requirements

To guarantee the right ventilation during the engraving of rubber, an exhaust

system with a minimum suction power of 300 m³/h is required. The device

must be equipped with a fine dust filter (generation of rubber dust) as well as

an activated carbon filter (neutralization of smells). A good filtering of the

outgoing air is also required when cutting plastics or engraving wood. If only

anodized plates are engraved, the suction power can be reduced.

Connection - see section 3.8.3 Connecting the Exhaust System.

Do not start the machine without an adequate exhaust system.

3.6 Cooling System – Requirements

For units with water-cooled laser sources the installation of a cooling

aggregate is required.

Connection - see section 3.8.4 Connecting the Cooling System.

3.7 Computer – Requirements

The following recommendation represents the minimum requirements.

When using a more powerful computer the graphics are generated and

displayed faster and the computing times and the data transfer to the laser

are reduced. To use the newest software version, you might have to abide

other requirements.

 Windows 7® 32/64-bit or

Windows Vista® 32/64-bit (with Service Pack 1 or later) or

Windows® XP 32/64-bit (with Service Pack 2 or later)

 512 MB of RAM, 400 MB of hard disk space

 Pentium® 1 GHz processor or AMD Athlon™ XP

 1024 x 768 or better monitor resolution

 24-bit color depth graphics card

 1 free USB interface

 Serial port RS232 for troCAM and/or i-Cut

 CD drive

 Mouse