D-Link DVA-G3340S Инструкция по эксплуатации онлайн [13/78] 41892

D-Link DVA-G3340S Инструкция по эксплуатации онлайн [13/78] 41892
MTU
The Maximum Transmission Unit size may be changed
if you want to optimize efficiency for uploading data
through the WAN interface. The default setting (1400
bytes) should be suitable for most users. Some user
may want to adjust the setting to optimize performance
for wireless traffic or when low latency is desired (such
as with Internet gaming). It is highly recommended that
the user research how adjusting the MTU may effect
network traffic for better or worse.
MRU
Similar to the MTU, except this applies to Maximum
Received Unit size for downloading data. Most users
will be happy with the default setting (1492 bytes).
However this may also be optimized for fast
downloads of general bulk Internet traffic, for low
latency or for downloading to computers on the
Wireless LAN. As with the MTU setting, the user
should carefully consider how changing the MRU may
effect Internet downloads for all systems on your LAN.
Default Route
When this is enabled, the Router will be considered to
be the primary gateway to the Internet and WAN for
systems on your network. If you are using the Router
on a network with one or more alternative gateway
routers, you may prefer to disable this if you will use
another router as the primary gateway.
NAT
Network Address Translation may be enabled or
disabled with the pull-down menu. Keep in mind that
disabling NAT allows on a single computer to be used
for Internet access through the Router. NAT is enabled
and disable for the Router on all connections (i.e. Pvc0
– Pvc7) if your Router is set up for multiple virtual
connections.
Firewall
Use this to universally enable or disable the Firewall
and Filter features available in the Router. If you
disable this you will not be able to configure settings in
the Firewall or Filters menus in the Advanced
directory.
IP Control
This is used to determine how global IP settings are
handled for the WAN interface. Typically PPPoE or
PPPoA connections will use the default setting for
Dynamic IP. Some users will be given a specific IP
address for the WAN interface. In this case you need
to change this setting to Static IP. When Static IP is

Похожие устройства

Скачать