Tektronix MSO46 — как подключить пробники к осциллографам серии MSO6 [69/628]

Figure 8: Connecting probes to the MSO6 Series

Connecting Probes

Connect TPP Series, TekVPI+, TekVPI, or other supported Tektronix analog probes by pushing them into a FlexChannel

connector. The probe base latch locks with a 'click' when the probe is fully seated.

TekVPI probes automatically set the channel input parameters for that probe (bandwidth, attenuation, termination, and so on). If

a probe has a Menu button, push that button to open an on-screen configuration menu. Follow instructions provided with active

probes to set their parameters (auto zero, degauss, and so on).

To connect a TLP058 FlexChannel Logic Probe or a TDP7700 Series TriMode

™

Probe:

1. Move the locking lever to the unlocked position, then let go to reset locking lever to the center position.

2. Insert the probe into a FlexChannel connector until fully seated and the lock mechanism clicks.

3. Move the locking lever to the locked position. The status light should be a solid green.

4. To disconnect the TLP058 probe, move and hold the locking lever at the unlocked position and pull out the probe. Do not

pull on the ribbon cable while removing the probe.

Connect a BNC probe or cable by pushing it onto a channel BNC bayonet connector and turn the lock mechanism clockwise until

it locks.

NOTE. Connecting a probe does not automatically enable that channel (make it active). Use the instrument controls or

programmatic interface to turn on a channel and open its configuration menu to verify or change probe or cable settings

(bandwidth, attenuation, termination and so on).

Install your instrument

4/5/6 Series MSO Help 39