Magicard Rio Pro [30/33] Table 1 printer error messages continued
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Magicard Rio Pro [30/33] Table 1 printer error messages continued

Magicard Rio Pro 360 [30/33] Table 1 printer error messages continued
ID Card Printer – User Manual
ID Card Printer – User Manual
- 30 -
Table 1 - Printer Error Messages (continued……)
Error Message Probable Cause Solution
1. Che
ck the inside of the printer for
obstructions.
Can't Drop Head, Check
Printer Mechanism.
Code = 17:00 to 17:01
The printer is attempting to move
internal mechanical parts, but does
not detect any movement
2. Check to make sure the correct power
supply is connected
Mag Verify Fail,
1. Make sure you have the correct power
supply plugged into the printer.
Press Retry or Cancel to
continue.
Code = 19:00 to 19:02
The printer does not detect the RFID
PCB
2. Try installing a new roll of ribbon.
The pri
nter has printed more than
700 cards since the rollers were last
cleaned. It needs to be cleaned to
prevent deterioration of print
performance.
Clean Required,
Please clean rollers to
avoid deterioration.
1. Clean the print rollers.
Code = 21:00 to 20:01
Wrong PSU?
Please switch printer OFF
and check the power
supply.
Code = 23:00
The printer detects a low level of
output from the Power Supply Unit.
1. Make sure the correct power supply is
connected.
Table 2 - Dye Film Problems
Problem Probable Cause Solution
Dye film cutting during the
print operation
1. Ribbon sticking to card 1. Ensure cards are not already used.
Then lower the printhead power
settings.
2. Image printing over the ends of
the card. 2. Adjust either the image start if
cutting at beginning of film panel, or
the image end if cutting at rear of
film panel.
Image is printed outside
the colour panels. (Puts a
coloured band across one
end of card).
1. A used roll of dye-film has been
fitted.
1. Fit a new roll of film.
2. Take up spool wound too loosely.
2. Remove loose film.
Areas of Dye film peeling
off card. Dark ‘mosaic’ like
image.
1. Card has been used and has
overcoat layer on it.
1. Use only brand new cards not ones
which failed to print fully.
Cards printed incorrectly
after switching between
YMCK and black film
1. Failure to re-set driver settings 1. Set correct the driver settings for
Colour Format. 2. A used roll of dye-film has been
fitted. 2. Replace dye film with a new roll.

Содержание

Похожие устройства

Скачать