Dometic TEC 40D [18/340] Checking the oil level

Operating the generator TEC40D

8.7 Checking the oil level

Always check the oil level before use. To do this, proceed as follows:

➤ Open the generator cover.

➤ Switch the generator to no function with the main switch (fig. 4 1, page 4).

➤ Disconnect the positive terminal of the supply battery.

➤ Take the dipstick (fig. 4 2, page 4) out of the filler neck (fig. 4 3, page 4).

➤ Clean the dipstick (fig. 4 2, page 4) with a cloth.

➤ Put the dipstick (fig. 4 2, page 4) back into the filler neck (fig. 4 3, page 4).

➤ Take the dipstick (fig. 4 2, page 4) out of the filler neck.

➤ Check that the oil level is between the notch (maximum filling level) and the tip of

the dipstick.

If not, top up with more oil.

➤ Put the dipstick (fig. 4 2, page 4) back into the filler neck (fig. 4 3, page 4).

➤ Connect the generator to the positive terminal of the supply battery.

➤ Switch the generator to standby with the main switch (fig. 4 1, page 4).

➤ Close the generator cover.

GEN ON

The generator is operating nor-

mally.

Normal mode –

GEN OFF

The generator is in stand-by and

can be started.

–

CAUTION!

Hot oil can cause burns.

Only check the oil level when the generator is switched off.

NOTE

The generator must be level.

Display message

Description

Generator behaviour Measures

TEC40D-O-16s.book Seite 18 Freitag, 12. August 2016 7:10 19