Kastor KARHU 20 PK VV [40/88] Installation and preparation for use

40

• Remove all extra stickers and protective plastic (excluding type/CE mark stickers).

• Make sure that the grate (chapter 2.8 ) is in place.

• Install the connecting tube to the flue opening above the heater.

• Check the sweeping opening and flue opening lids.

2. Installation and preparation for use

2.1. Preparing for use and burn-in

• Install door handle

• Install the connecting tube to the flue opening above the heater.

• Check the sweeping opening and flue opening lids.

• Burn-in: The purpose of the burn-in is to remove out of doors any flammable protective

coating substances and to harden the stove’s coating. Burn a few full loads of wood in the

fire compartment. Continue the burn-in until there are no more fumes rising from the

stove.

• Once the stove has cooled down after the burn-in, move it into the sauna.

• See to it that the sauna is well ventilated during the first couple of heating.

2.1.2 SIDE WATER TANK VO and VV

Water tank lid

In order to avoid damage during transport, the heater water tank tap has been stored inside.

A tap, two seals and a nut are included. Water tap is attached on the sauna side. It is

attached as follows: (Image 1)

• Water tank is lifted.

• First seal is placed on the tap thread.

• Tap is pushed into the hole on the heater cover.

• The other seal is placed on the tap thread inside the cover.

2.1.3 FRONT WATER TANK ES

Empty the water tank before outside temperatures drop below zero; the tank is damaged if

water freezes in it.

Water tank lid