Home
Главная
IKA
Мельница
A 10 basic 0004020700
Руководство по эксплуатации Страница: 15

IKA A 10 basic 0004020700 [15/100] Safety instructions

• Do not crush explosive, toxic or noxious substances.

• Please observe the relevant safety instructions and

guidelines regarding dust explosions.

• Please follow the relevant safety instructions and guide-

lines, and occupational health and safety regulations for

use in the laboratory. When working with the mill, the

user must wear his personal protective equipment.

• Always wear suitable protective equipment when em-

brittling the mill feed with coolants (dry ice).

Never cool the samples with liquid

nitrogen inside A10 basic grinding

chamber. If the samples have to be

cooled with liquid nitrogen, please cool them ﬁrst be-

fore ﬁlling into A10 basic grinding chamber.

• Ensure that the chamber cap is tightly closed.

Before removing the chamber cap,

switch off the mill and wait until the

motor stops. Beware of risk posed by

trailing grinding tool.

• Always switch off the instrument and disconnect the

plug before cleaning or replacing parts.

The grinding pot, grinding tool and

rotor shaft may be hot after long

grinding cycles. Allow the mill to cool

down before cleaning or before changing grinding tool.

Beware of the sharp edged cutter

in particular when changing grind-

ing tool and when cleaning. Always

wear your personal protective equipment (protective

gloves, etc.).

• Ensure that pressure does not build up in the grinding

chamber (particularly when using coolants).

• The instrument can only be opened by trained special-

ists, even during repairs. The machine is to be unplugged

from the mains before opening. Live parts inside the

machine may still be live for some time after unplugging

from the mains.

Safety Instructions

•

Read the operating instructions fully before start

ing up and follow the safety instructions.

• Keep the operating instructions in a place where they

can be accessed by everyone.

• Ensure that only trained staff work with the instrument.

• Follow the safety instructions, guidelines, occupational

health and safety and accident prevention regulations.

• The instrument must be always supervised when in op-

eration.

• Hearing protection must be worn when working with

the instrument at high speed.

• Set up the instrument in a spacious area on an even,

stable, clean, non-slip, dry and ﬁreproof surface.

• The feet of the instrument must be clean and undam-

aged.

• The instrument is not suitable for hand held operation.

• The instrument may heat up when in use.

• Check the instrument and accessories for damage be-

fore each use. Do not use damaged components.

Please pay attention to avoiding

hand injury when operate the instru-

ment.

Always open the chamber care-

fully after use, as the material in the

chamber may heat up due to transfer

of energy during operation. Wear gloves if necessary or

wait for material to cool down.

• Beware of the risk of ﬂammable materials.

• Do not operate the instrument in explosive atmo-

spheres, with hazardous substances or under water.

• The instrument doesn’t start up again automatically fol-

lowing a cut in the power supply.

• Safe operation is only guaranteed with the accessories

described in the ”Accessories” chapter.

• Socket must be earthed (protective ground contact).

• The instrument could only be disconnected from the

mains supply by pulling out the mains plug or the con-

nector plug.

• The socket for the mains cord must be easily accessible.

• The voltage stated on the nameplate must correspond

to the mains voltage.

• Protect the instrument and accessories from bumps and

impacts.

Only process dry solid sample with

the instrument. Never use it for pro-

cessing liquid or wet samples.

DANGER

WARNING

IKA A 10 basic 0004020700 [15/100] Safety instructions

Содержание

Похожие устройства