Invertek Drives ODV-42075-IN [6/24] The ip55 nema 12 optidrives can be installed side by side the ip55 nema 12 optidrives can be installed side by side with their heatsink flanges touching this gives...

3. Mechanical Installation

3.1. General

• Store the Optidrive in its box until required. Storage should be clean and dry and within the temperature range –40°C to +60°C

• Install the Optidrive on a flat, vertical, flame-resistant, vibration-free mounting within a suitable enclosure, according to

EN60529 if specific Ingress Protection ratings are required

• The Optidrive must be installed in a pollution degree 1 or 2 environment

• The IP55/NEMA 12 drive is intended for INDOOR USE ONLY

• Ensure that all terminals are tightened to the appropriate torque setting

3.2. Mechanical dimensions and mounting

A B C D E F G H I J

Drive

Size

mm in mm in mm in mm in mm in mm in mm in mm in mm in mm in

200 7.87 166 6.54 - - 141 5.55 33 1.30 162 6.38 140 5.51 128 5.04 4.2 0.17 8.4 0.33

310 12.20 276 10.87 - - 251 9.88 33 1.30 176 6.93 164 6.46 153 6.02 4.2 0.17 8.4 0.33

310 12.20 276 10.87 - - 251 9.88 33 1.30 228 8.98 210.5 8.29 197.5 7.78 4.2 0.17 8.4 0.33

NOTE

The size 3 product has 4 symmetrical mounting points

Control Terminal Torque Settings of 0.5 Nm (4.5 lb-in) Power Terminal Torque Settings of 1 Nm (9 lb-in)

The IP55 / NEMA 12 Optidrives can be installed side-by-side

with their heatsink flanges touching. This gives adequate

ventilation space between drives.

If the IP55 Optidrive is to be installed above another drive or

any other heat-producing device, the minimum vertical spacing

is 150mm (5.9 inches)

6 Optidrive E2 IP55/NEMA 12 User Guide

www.invertek.co.uk