Qtech QSW-8200-28T-POEAC- DC [10/74] Match ipv6 address

User Manual

Chapter 1. Commands for Routing Policy 10

www.qtech.ru

 no match ip <address | next-hop> [<ip-acl -name | ip-acl -num | prefix-

list list-name>]

 Function: Configure the routing prefix or next-hop. The “no match ip <address | next-

hop> [<ip-acl -name | ip-acl -num | prefix-list list-name>]” deletes this configuration.

 Parameter: <address > means matching the routing prefix, <next-hop>means matching

the routing next-hop, <ip-acl -name > is the name of ip access-list, <ip-acl -num > is the

ip access-list sequence number, ranging between 1～199 or 1300～2699 (extension

scope), prefix-list means the matching should follow the prefix-list rules, list-name is

the name of prefix-list.

 Command Mode: route-map mode

 Usage Guide: This command matches according to the next-hop messages or routing

prefix in the route. If the matching succeeded, then the “permit” or “deny” action in

the route-map is performed.

 Example:

 Switch#config terminal

 Switch(config)#route-map r1 permit 5

 Switch(config-route-map)#match ip address prefix-list mylist

1.8 match ipv6 address

 Command: match ipv6 address <ipv6-acl-name | prefix-list list-name>

 no match ipv6 address [<ipv6-acl-name | prefix-list list-name>]

 Function: Configure the prefix for ipv6 routing. If the no form command is enaled, the

configuration will be removed.

 Parameters: address is the routing prefix to be matched. <ipv6-acl-name> is the name

of ipv6 access list. Or when the prefix-list is configured. list-name will be the list name

to be matched.

 Command Mode: route map mode

 Usage Guide: When this command is enabled, the prefix-list in the routing table will be

used for routing decision. And if matched, the permit deny operation in the route map

will be executed.

 Example:

 Switch#config terminal

 Switch(config)#route-map r1 permit 5

 Switch(config-route-map)#match ipv6 address prefix-list mylist

1.9 match ipv6 next-hop

 Command: match ipv6 next-hop <ipv6-address>

 no match ipv6 next-hop [<ipv6-address>]

 Function: Configure the next hop for ipv6 routing. The no form command will disable

the configuration.