Qtech QSW-8200-28T-POEAC- DC [16/74] Set ip next hop

User Manual

Chapter 1. Commands for Routing Policy 16

www.qtech.ru

 Switch(config-route-map)#set extcommunity rt 100:10

 Set soo as 200.200:10

 Switch(config)#route-map r1 permit 10

 Switch(config-route-map)#set extcommunity soo 200.200:10

1.21 set ip next-hop

 Command: set ip next-hop <ip_addr>

 no set ip next-hop [<ip_addr>]

 Function: Configure the next-hop of the route. The “no set ip next-hop [<ip_addr>]”

command deletes the configuration.

 Parameter: <ip_addr > is the ip address of next-hop shown with dotted decimal

notation.

 Command Mode: route-map mode

 Example:

 Switch#config terminal

 Switch(config)#route-map r1 permit 5

 Switch(config-route-map)#set ip next-hop 10.2.2.2

1.22 set local-preference

 Command: set local-preference <pre_val>

 no set local-preference [<pre_val>]

 Function: Configure the local priority of BGP route. The “no set local-preference

[<pre_val>]” command deletes this configuration.

 Parameter: <pre_val > is the value of local priority, ranging between 0～4294967295.

 Command Mode: route-map mode

 Usage Guide: The local priority attribute is the priority level of a route. A route with a

higher local priority level when compared with other route of the same destination, will

be more preferred than other route. The local priority validates only within this AS and

will not be transported to EBGP neighbors. To use this command, one match clause

should at first be defined.

 Example:

 Switch#config terminal

 Switch(config)#route-map r1 permit 5

 Switch(config-route-map)#set local-preference 60

1.23 set metric

 Command: set metric < metric_val>