Qtech QSW-8200-28T-POEAC- DC [72/74] Ipv6 rip bfd enable

User Manual

Chapter 6. Commands for BFD 72

www.qtech.ru

 Usage Guide: Configure BFD for OSPFv3 instance on the specific interface which enable

OSPFv3 protocol, BFD will inform OSPFv3 after detect link fault and OSPFv3 will deal

with it in best times.

 Example: Enable BFD for OSPFv3 on interface.

 s5(config-if-vlan50)#ipv ospf bfd enable instance-id 254

6.16 ipv6 rip bfd enable

 Command: ipv6 rip bfd enable

 no ipv6 rip bfd enable

 Function: Configure BFD for RIPng protocol on the specific interface, no command

cancels the configuration.

 Parameter: None.

 Default: BFD is not enabled for RIPng.

 Command Mode: Interface configuration mode

 Usage Guide: Enable BFD for RIPng protocol, after that, if this interface has received

RIPng packets, RIPng will inform BFD to set remote ip as session and detect the state in

order to inform RIPng in time.

 Example: Enable BFD for RIPng.

 s5(config-if-vlan50)#ipv6 rip bfd enable

6.17 ipv6 route bfd

 Command: ipv6 route {vrf <name> <ipv6-address> | <ipv6-address>} prefix <nexthop>

bfd

 no ipv6 route {vrf <name> <ipv6-address>|<ipv6-address>} prefix <nexthop> bfd

 Function: Configure BFD for the static IPv6 route, no command cancels the

configuration.

 Parameter: <name> is vrf name, <ipv6-address> is destination address, prefix is prefix

length, vlanid is output interface, nexthop is nexthop address.

 Default: BFD is not configured for the static IPv6 route.

 Command Mode: Global mode

 Usage Guide: Configure BFD for the route and specify the detection mode.

 Example: Configure BFD for the static IPv6 route.

 s3(config)#ipv6 route 3000::/64 2010::1 bfd