Planet WGS3-5220 [503/528] No ip igmp startup query count only for layer 3 series

User’s Manual of WGS3-2820/WGS3-5220
503
range for <count> is 1 to 20.
Default 2
Format ip igmp startup-query-count <count>
Mode nterface Config
no ip igmp startup-query-count (only for Layer 3 Series)
This command resets the number of Queries sent out on startup, separated by the Startup Query Interval on the interface to the
default value.
Format no ip igmp startup-query-count
Mode Interface Config
13.3.10 ip igmp startup-query-interval
This command sets the interval between General Queries sent by a Querier on startup on the interface. The time interval value
is in seconds. The range for <interval> is 1 to 300 seconds.
Default 31
Format ip igmp startup-query-interval <interval>
Mode Interface Config
no ip igmp startup-query-interval
This command resets the interval between General Queries sent by a Querier on startup on the interface to the default value.
Format no ip igmp startup-query-interval
Mode Interface Config
13.3.11 set igmp groupmembershipinterval
This command sets the IGMP Group Membership Interval time on a particular interface or VLAN. The Group Membership
Interval time is the amount of time in seconds that a switch will wait for a report from a particular group on a particular interface
before deleting the interface from the entry. This value must be greater than the IGMPv3 Maximum Response time value. The
range is 2 to 3600 seconds.
Default 260 seconds
Format set igmp groupmembershipinterval <vlanId> <2-3600>
Mode Interface Config Vlan Mode
no set igmp groupmembershipinterval
This command sets the IGMPv3 Group Membership Interval time (on the interface or the VLAN) to the default value.
Format no set igmp groupmembershipinterval
Mode Interface ConfigVlan Mode

Содержание

Скачать