Icom IC-F43TR [13/40] Turning power on

BASIC OPERATION

■ Turning power ON

q Rotate [VOL] to turn the power ON.

w If the transceiver is programmed for a start up passcode,

input the digit codes as directed by your dealer.

 •Thekeysinthetablebelowcanbeusedforpasswordinput:

 •Thetransceiverdetectsnumbersinthesameblockasidentical.

Therefore“01234”and“56789”arethesame.

eWhenthe“PASSWORD”indicationdoesnotclearafterin-

putting 4 digits, the input code number may be incorrect.

Turn the power off and start over in this case.

■ Channel selection

Push [UP] or [DOWN], or rotate [ROTARY SELECTOR]

to select the desired system channel or talk group, in se-

quence.

•Upto16pre-programmedchannelscanbeselectedvia[ROTARY

SELECTOR].

■ Call procedure

When your system employs tone signalling (excluding

CTCSS and DTCS), the call procedure may be necessary

prior to voice transmission. The tone signalling employed may

be a selective calling system which allows you to call speciﬁc

station(s) only and prevent unwanted stations from contact-

ing you.

q Select the desired DTMF encode channel according to

yourSystemOperator’sinstructions.

 •Thismaynotbenecessarydependingonprogramming.

 •Refertopages10,13or15forselection.

w Push the [PTT].

e After transmitting a DTMF code, the remainder of your

communication can be carried out in the normal fashion.

Selective calling

Non-selective calling

KEY

NUMBER