Home
Главная
Metabo
KS 254 Plus
Инструкция по эксплуатации Страница: 27

Metabo KS 254 Plus [27/63] English

Metabo KS 305 Plus [27/63] English

ENGLISH

27

2. Remove the table insert.

3. Put in a new table insert.

4. Tighten the table insert fixing

screws.

8.3 Drive belt tensioning

The drive belt (82), running on the right-

hand side of the sawhead behind a pla-

stic cover, needs to be re-tensioned if it

can be depressed more than 8 mm

halfway between the two pulleys.

To check, re-tension and change:

1. Remove screws (84) and take plastic

cover (83) off.

2. Check belt tension by thumb pressu-

re.

If the drive belt needs to be re-tensio-

ned or replaced:

– Loosen all hexagon socket

screws of the motor mount by

approx. one turn.

– Re-tension or replace the drive

belt. To tighten slide the motor to

the rear.

– Tighten motor fastening screws

crosswise.

3. Replace the plastic cover (83) and

secure with the screw.

8.4 Adjustments

Fence adjustment

1. Snap the rotary table into the 0° po-

sition and lock it in place with the

lock screw.

2. Swing sawhead down and engage

transport locking pin with deep

groove.

3. If necessary, remove the chip bag

or disconnect the dust extractor

from the saw.

4. Lift the saw by the front legs, tip it

with the weight on the back legs

and carefully set it down on the

back legs and motor.

5. Loosen the screws on the underside

by two turns:

6. Place the saw back on its legs.

7. Align the rotary table with the fence

in such a way that the fence is ex-

actly at right angles to the saw bla-

de.

8. Re-tighten the screws on the under-

side.

Mitre angle indicator adjustment

1. Loosen screw (86) approx. one turn.

2. Adjust pointer (85) until the indica-

ted value corresponds with the cur-

rent stop position of the rotary table.

3. Tighten screw (86).

Bevel tilt positive stop adjustment

1. Snap the track arm holder into the

0° position, but do not tighten the

lock lever

(87).

2. Loosen the two socket cap screws

on the rear of the saw by approx.

one turn:

3. Adjust the track arm holder until the

saw blade is exactly 90° to the rota-

ry table.

4. Tighten the two socket cap screws on

the rear of the saw again.

5. Tighten lock lever (87).

6. Loosen the screws (88) approx. one

turn.

7. Adjust pointer (89) until the indica-

ted value corresponds with the cur-

rent stop position of the track arm

holder.

81

83 84

82

85 86

87

Содержание

Похожие устройства