Home
Главная
Bomann
Пылесосы
BS 989 CB
Инструкция по эксплуатации Страница: 25

Bomann BS 989 CB [25/42] Maintenance

Using the Appliance

1. Unwind the length of cable you require.

CAUTION:

• Pull out the cable up to the maximum length

indicated with the yellow mark.

• Never pull the cable out up to the red mark as

the cable winding can be damaged.

NOTE:

If the red mark is visible, pull in the cable with the

help of the cable winding button back to the yellow

mark.

2. Insert the mains plug into a correctly installed power

socket. Turn the device on by the on/off switch by

pressing down the button.

3. Set the “carpet/hard oor” switch, depending on the

oor covering.

4. Vacuum at a steady speed. There is no need to exert

pressure.

NOTE:

Pay attention to the range that can be covered with

the cable length!

Air Slide

Open the air slide on the hose handle

in order to regulate the airow or to

clear any particles sticking to the noz-

zle.

Switching off and Winding up the Mains Lead

1. Turn the vacuum cleaner off by the on/off switch and

remove the plug from the socket.

2. Keep the plug in your hand.

3. Press the cable winding button and guide the cable.

Hold the cable to avoid wrapping.

Nozzle Attachment

Crevice and

jointed nozzle: For vacuuming upholstery,

curtains and in corners and

crevices etc.

NOTE: “2-in-1” nozzle:

When this is folded together

it can be used as a groove

nozzle. If you would like to use

the brush nozzle, pull the brush

section in the direction of the

arrow until it locks in place.

Floor nozzle: To clean carpets or smooth

surfaces.

Smooth oors: Press down the

lever with the

brush symbol

with your foot.

The brush is now

visible.

Carpets: Press the lever

In the opposite

direction. The

brushes are now

retracted.

Releasing the nozzles: Pull these off while turning

slightly.

Maintenance

Dust bag replacement display (2)

Hold the hose up into air. If the display for the vacuum

bag change shows “red”, the dust bag is full. Please

change it.

Changing the dust bag

• Pull the plug out of the socket.

• Open the lid of the dust bag compartment by the han-

dle (5).

• Remove the bracket with the dust bag.

• Then remove the dust bag by pulling it upwards.

• Insert a new bag. Please ensure that the bag is

located correctly in the guide mechanism.

• Fit the bracket with the new dust bag back into the

appliance. Press down the fastener with the bag. The

bag must be located completely in the dust bag com-

partment. Close the cover so that it snaps into place.

Filter

Your appliance has two lters.

Motor protection ﬁlter (inlet ﬁlter)

The inlet lter is located in the dust bag compartment.

The lter is located vertically in the rear section of the

dust housing. Remove the lter by pulling upwards.

Cleaning the Filter Element

Clean the engine protection lter after 10 dust bag chang-

es. If necessary, the lter can also be washed in warm

water without any additives. Place it back into place only

once it is completely dry!

Outlet ﬁlter

The appliance is also equipped with an outlet lter.

It is located on the back of the device under the parking

aid.

• Press the lever (9) to the left and remove the ventila-

tion grille.

Bomann BS 989 CB [25/42] Maintenance

Содержание

Похожие устройства