Oleo-Mac PW 170 C Инструкция по эксплуатации онлайн [23/140] 91833

Oleo-Mac PW 170 C Инструкция по эксплуатации онлайн [23/140] 91833

•Ifdetergentisswallowed,donotprovokevomiting.Contactadoctorwithoutdelayandremembertotakethe
containerofdetergentwithyou.
•Whenllingthetankwithdetergent,takecarenottospillanydetergentonthehighpressurecleaner.Ifthisshould
happen,waitatleast24hoursbeforeusingthehighpressurecleanersothatanyliquid,whichmayhaveentered
theappliance,canevaporate.
The recommended detergents, are over 90% biodegradable.
For information on how to use the detergents, refer to the instructions in the table and on the label on the container
of detergent.
In case of suction from the water cleaner tank (only PW 170C - IP 1700S):
- Remove the plug  and, by paying attention that the uid does not overow, ll the tank (maximum capacity
1.75l/0.46 US gal.) by following the recommendations relating to the proportion indicated on the detergent package
label.
- Operate the nozzle-holding multi-adjusting head as shown in Fig.  and activate the water gun lever 
and start the detergent spraying operation.
- Operate the nozzle-holding multi-adjusting head  as shown in Fig.  to reset the high-pressure operation.
In case you use the foaming lance  (only PW 160 - PW 160C - IP 1600), insert it on the water gun  and switch
on the device (the suction and the mixing take place automatically when the water ows by).
5.4InterruptInGuse(totalstop)
Release the lever  on the cleaner gun and the water cleaner will automatically stop.
The water cleaner starts operating normally again when the lever on the cleaner gun is pressed again.

•ItisimportanttorememberthatthehighpressurecleanerisstilloperationalwhenitisinTotalStopmode.
Therefore,alwaysputthemainswitch(1)inposition“0”,removetheplugfromthepoweroutlet,pressthelever(9)
onthecleanerguntoeliminateanyremainingpressureandlockthesafetyprotectiondevice(10)(Fig.B),before
leavingitunattended,evenforashorttime.
6 sWItChInGoffandstoraGe
After cleaning, switch the water cleaner off and prepare it for storage.
6.1sWItChInGoff
Close the tap for the water supply securely.
Empty the water out of the water cleaner by pressing the lever on the cleaner gun for a few seconds.
Put the main switch  in position .
Remove the plug from the power outlet.
Press the lever on the cleaner gun to eliminate any remaining pressure in the high-pressure pipe .
Rewind the power supply cable  with care and hook it to its support .
Wait for the high pressure cleaner to cool down.

•Whenthewatercleanerislefttocooldown,takecarethat:
-thewatercleanerisnotleftunattendedinthepresenceofunsupervisedchildren,elderlyordisabledpeople.
-thewatercleanerisinastablepositionandnotatriskoffallingover.
-thewatercleanerisnotincontactwithinammablematerials,orintheirimmediatevicinity.
6.2storaGe
Wind up the high-pressure pipe  carefully and avoid bending it.
Wind up the electric power supply cable .
Put the water cleaner in a clean and dry place making sure that the electric power supply cable and the high-pressure
pipe are not damaged.

The water cleaner is not frost proof.
In order to prevent the formation of ice inside the water cleaner in cold areas, it is possible to make the high
pressure cleaner take up a motor vehicle grade anti freeze before starting the  procedures. Contact
a  before attempting this as the pumped liquid could damage the seals in the high-pressure
pump.
GB

Содержание

Похожие устройства

Скачать
Случайные обсуждения