ADJ Accu Fog1000 DMX Руководство по эксплуатации онлайн [15/20] 759002

American DJ® - www.americandj.com - Accu Fog 1000 Instruction Manual Page 29

American DJ® - www.americandj.com - Accu Fog 1000 Instruction Manual Page 30

02Er – TILT movement error:

If the head is not located in the default tilt position after start-

up or after a reset command. This message will appear after a

xture reset, if the tilt magnetic-indexing circuit malfunctions

(sensor failed or magnet is missing) or there is a stepper motor

failure (defective motor or a defective motor IC drive on the

main PCB).

Accu Fog 1000 Error Codes Accu Fog 1000 Error Codes

When power is applied, the unit will automatically enter a

“reset/test” mode. This mode brings all the internal motors to a

home position. If there is an internal problem with one or more

of the motors an error code will ash in the display in the form

of “XXer”, “XX” will represent a function number. For example,

when the display shows “02Er,” it means there is some type

of error with the channel 2 motor. If there are multiple errors

during the start-up process they will all ash in the display. For

example: if the xtures has errors on channel 1 and channel 2

at the same time, you will see the error message ash “01Er”

and “02Er” repeated 5 times.

If an error does occur during the initial start-up procedure the

xture will self-generate a second reset signal and try to realign

all the motors and correct the errors, if the errors persist after a

second attempt a third attempt will be made.

If after a third attempt all the errors have not been corrected the

xture will make the following determinations:

1) 3 or more errors - The xture cannot function properly with

three or more errors therefore the xture will place itself in a

stand-by mode until subsequent repairs can be made.

2) Less than 3 errors - If the xture has less than 3 errors, there-

fore most other functions will work properly. The xture will

attempt to operate normally until the errors can be corrected by

a technician. The errors in question will remain ashing in the

display as a reminder of internal errors.

01Er – PAN movement error:

If the yoke is not located in the default position after start-up or

after a reset command. This message will appear after a xture

reset, if the pan-yoke’s magnetic-indexing circuit malfunctions

(sensor failed or magnet is missing) or there is a stepper motor

failure (defective motor or a defective motor IC drive on the

main PCB).