Ada GroundDrill-3 [14/38] Ground drill 3

MEASUREMENT FOUNDATION

GroundDrill - 3

10. Long term storage

When storing for more than a month:

1) Remove fuel from tank. Run engine until it runs out of fuel.

2) Clean the inside of fuel tank and the fuel lter with clean gasoline.

3) Remove the spark plug and put small amount of dean motor oil in the spark plug hole. Pull the starter about two or three times, then

stop pulling when the piston is at the top. Replace the plug.

4) Clean the external parts of the motor with a cloth soaked in oil and leave the motor in a dry place away from re or heat.

Suggestion: Motors stored for long periods with gas in the tank and carburetor will have reduced performance.

11. Prolonging the life of your machine

1) Always keep your machine in good condition

2) Check for loose parts. Tighten any loose parts before use.

3) When storing:

- Drain the fuel tank and start the motor to burn any remaining fuel

- Remove the spark plug and put oil in the cylinder. Put back plug and pull start engine a few times

- Check the air lter. Clean before using.

- Keep the motor in a dry place. Make sure it is kept away from dust.

- Always repair damaged parts before using.

Suggestion: If the unit is stored for long periods with gas in the tank or carburetor, sediment will cause performance problems.Rre-

move fuel from the tank and carburetor before storing.