RME HDSP 9632 [25/87] Digital recording

User's Guide HDSP System HDSP 9632 © RME

12.5 Digital Recording

Unlike analog soundcards which produce empty wave files (or noise) when no input signal is

present, digital I/O cards always need a valid input signal to start recording.

To take this into account RME included a comprehensive I/O signal status display (showing

sample frequency, lock and sync status) in the Settings dialog.

The sample frequency shown in the Settings dialog (see chapter 11, screenshot Settings) is

useful as a quick display of the current configuration (the box itself and all connected external

equipment). If no sample frequency is recognized, it will read ‘No Lock’.

This way, configuring any suitable audio application for digital recording is simple. After select-

ing the required input, Hammerfall DSP displays the current sample frequency. This parameter

can then be changed in the application’s audio attributes (or similar) dialog.

The screenshot to the right shows a typical

dialog used for changing basic parameters

such as sample frequency and resolution in

an audio application.

Any bit resolution can be selected, provid-

ing it is supported by both the audio hard-

ware and the software. Even if the input

signal is 24 bit, the application can still be

set to record at 16-bit resolution. The lower

8 bits (and therefore any signals about

96dB below maximum level) are lost en-

tirely. On the other hand, there is nothing to

gain from recording a 16-bit signal at 24-bit

resolution - this would only waste precious space on the hard disk.

It often makes sense to monitor the input signal or send it directly to the output. This can be

done at zero latency using TotalMix (see chapter 27).

An automated control of real-time monitoring can be achieved by Steinberg’s ASIO protocol

with our ASIO 2.0 drivers and all ASIO 2.0 compatible programs. When 'ASIO Direct Monitoring'

has been switched on, the input signal is routed in real-time to the output whenever a recording

is started (punch-in).

Note

: Under MME the feature 'Check Input' prevented recordings done at wrong sample rates.

Under WDM this functionality is limited. With Check Input activated Windows will automatically

(and without notice) perform a sample rate conversion. With Check Input deactivated the recor-

ding will simply be performed with the wrong sample rate, with a detuned playback later on.

Therefore Check Input has been removed from the Settings dialog of the WDM driver.