Bosch GWS 24-230 [23/337] Speed preselection

English | 23

The regulations on the material being machined that apply in

the country of use must be observed.

u Avoid dust accumulation at the workplace. Dust can

easily ignite.

Operation

Start-Up

u Pay attention to the mains voltage. The voltage of the

power source must match the voltage specified on the

does not have sufficient reserve capacity or an adequate

voltage control system with inrush current boost converter,

loss of performance or atypical behaviour may occur upon

switch-on.

Please check the suitability of the power generator you are

using, particularly with regard to the mains voltage and fre-

quency.

u Hold the tool by the insulated gripping surfaces and

auxiliary handle only. The application tool could come

into contact with hidden wiring or its own cord. Con-

To switch off the power tool, release the on/off switch (2);

or, if the switch is locked, briefly push the on/off switch (2)

backward and down and then release it.

u Always check abrasive tools before using them. The

abrasive tool must be fitted properly and be able to

move freely. Carry out a test run for at least one

minute with no load. Do not use abrasive tools that are

damaged, run untrue or vibrate during use. Damaged

abrasive tools can burst apart and cause injuries.

Kickback stop

sition and then switch the power tool on again.

Restart protection

GWS700/ GWS710(115)/ GWS750/ GWS750-100 I/

GWS750S

The restart protection feature prevents the power tool from

uncontrolled starting after the power supply to it has been

interrupted.

To restart the tool, set the on/off switch (2) to the "off" posi-

tion and then switch the power tool on again.

Starting current limitation

You can preselect the required speed using the speed preselection thumbwheel (22), even during operation. The information

in the table below describes the recommended values.

Material Application Application tool Thumbwheel position

Metal Removing paint Abrasive disc 2−3

Metal Brushing, removing rust Cup brush, abrasive disc 3

Metal, stone Grinding Grinding disc 4−6

Metal Rough grinding Grinding disc 6

Metal Cutting Cutting disc 6

The values specified for speed levels are guide values.

u The rated speed of the accessory must be at least

u Exercise caution when cutting slots in structural walls;

see the "Information on structural design" section.

u Clamp the workpiece if it is not secure under its own

weight.

u Do not load the power tool so heavily that it comes to a

stop.

Bosch Power Tools 1 609 92A 6KK | (07.06.2021)