KRAFT KF-HBM1043BGLR [18/44] Fire hazard

KRAFT KF-HBM1043BGLR [18/44] Fire hazard
18
hand blender
USer GUIde
!
RISK OF ELECTRIC SHOCK
The immersion blender must be connected to the 220-240 V / 50-60 Hz power supply
via a grounded outlet with a current of at least 10A. Incorrect grounding or a deviation
of the voltage parameters by more than 10% can cause unstable operation of the
device or electric shock.
Insert the plug of the power cord into the socket only after installing the device. Make
sure that there is free access to the plug.
Do not touch the plug of the power supply cable with wet hands. Wipe the plug dry,
clean it from dust and carefully insert it into the outlet. Dust, water, or weak contact
can cause a fire or electric shock.
The blender must be disconnected from the power supply when moving, servicing or
repairing. To disconnect, hold on to the plug, do not pull or pull the power cord.
Do not use the appliance with a damaged power cord or socket. Do not twist, bend,
or extend the power cord. Do not place heavy objects on it. Make sure that the cord
does not touch sharp edges or hot surfaces.
Do not use the blender outdoors, do not expose it to rain, moisture, direct sunlight,
or other atmospheric phenomena, as well as in rooms with high air humidity at an air
temperature below 0°C. Do not place the appliance on a wet surface, as well as in
places of smoke and dust.
Do not immerse the blender in liquids above the connection point of the nozzle with
the motor unit. Do not immerse the motor unit in any liquid and do not wash it in the
dishwasher. In any case, do not touch the blender with wet hands while it is working.
!
FIRE HAZARD
Use a separate outlet to connect the blender. Using the same outlet for several
appliances can lead to a fire. To avoid overloading the network, do not use other
high-power devices in the same circuit.
Make sure that the plug of the power cord is not damaged or deformed. A faulty plug can
overheat and cause a fire. Do not use adapters, extension cords or “tees” to connect the
device. If you smell a burning wiring, disconnect the power supply on the switchboard,
remove the plug of the device from the outlet and contact the service center.
Install the blender away from heat sources and heating devices, beware of sources
of ignition.
RISK OF DAMAGE
Install the blender on a flat, hard, dry surface to prevent it from falling and to avoid
injury or death.
Do not place heavy objects on the blender. Do not carry the device by holding it by
the power cord. After use, do not wrap the power supply wire around the device, as

Содержание

Похожие устройства

Скачать