Harper HWD-800D01 H00003319 [9/45] Connecting the disposer to the electric mains

Содержание

Похожие устройства

HÔME clamping nuts can be screwed onto the pneumatic button fitting Make sure the air button fits tight in the mounting hole 7 Slide the other end of the air tube with the clamping nut onto the sock et of the electrical switch installed on the bottom on the side wall on some models of the disposer body 8 Slide the clamping nut through the air tube up to the connection of the electrical switch and tighten it by hand until it stops 1 Drill a 25 mm hole In a suitable location on the worktop or top of the sink Some sinks may have a prepared hole to open which you need to remove the plug 2 Insert the ends of the air tube into the clamping nuts of the fittings and slide the tube one centimeter inside the nuts If one of the nuts is screwed onto the fitting of the pneumatic but ton then it must be unscrewed 3 Unscrew and remove the mount ing nut from the air button body while holding the rubber gasket in place 9 Check the operation of the pneu matic button without connecting the disposer to the electrical network Af ter strong pressing the button for full stroke a click should be heard in the disposer housing CONNECTING THE DISPOSER TO THE ELECTRIC MAINS 4 Place the air tube with the clamping nut on the air button fitting slide the nut along the tube and tighten it on the fitting by hand until it stops 5 Insert the other end of the air tube and then the air button body into the prepared hole 6 From the underside of the countertop or sink put on the tube and push the previously removed mounting nut to the pneumatic button then tighten it on the body by hand until it stops HARPER 9

Скачать