Zalman RESERATOR 1 [2/22] Www zalman co kr www zalmanusa com

RESERATOR 1

www.zalman.co.kr www.zalmanusa.com

1. Make sure that the power source’s output voltage and frequency are compatible with

the power input requirements of the water pump before installing. (Input voltage and

frequency of the water pump can be located on the box and sink cover.)

2.Do not place in dusty or humid conditions, under direct sunlight, or near a heat source

such as a room heater.

3. Do not drop or subject to excessive force.

4. Check CPU socket compatibility first.

5. Familiarize yourself with this manual.

6. Do not mix any contaminant with the coolant when filling, for it may cause product

failure.

7. Use of a multiple-outlet power strip is recommended, for you can connect or disconnect

power to the PC and the Reserator 1’s pump simultaneously.

Cautions & Warnings

When Installing

1. Always turn on the water pump first before using the system.

2. If the coolant isn’t circulating or the pump is making a strange noise, turn off the pc

system immediately.

3. Do not place any object on the product.

4. Install on a flat surface with no vibration or slant; do not tilt or lay horizontally.

5. Use distilled or tap water for coolant, regularly check the amount of coolant, and

replenish as needed.

6. If a leak is found, turn off the system immediately and examine the problem before

using the system again.

7. If the system will not be used for an extended period of time, turn off the water pump.

8. When moving the system, separate the reserator from the PC case before moving.

9. Make sure to not let any air bubbles into the Water Block and tubes while in use.

10. Always check that the water pump is properly functioning.

When in Use