Yamaha DRAG STAR XVS650 (1997) [166/360] Crankshaft and connecting rods

Содержание

Похожие устройства

CRANKSHAFT AND CONNECTING RODS ENG The stamped Y mark g on the connect ing rods should face towards the left side of the crankcase Be sure that the characters on the side of the cap and connecting rod are aligned Tighten the nuts Nuts connecting rod caps 36 Nm 3 6 m kg 26 0 ft lb CAUTION ________________________ When tightening the nuts be sure to use an F type torque wrench Without pausing tighten to full torque specifications Apply continuous torque between 3 0 and 3 6 m kg Once you reach 3 0 m kg DO NOT STOP TIGHTEN ING until final torque is reached If the tightening is interrupted between 3 0 and 3 6 m kg loosen the nut to less than 3 0 m kg and start again Remove the connecting rods and bear ings On each crank pin measure the width of the compressed Plastigauge If the oil clearance is out of specification select a replacement bearing 8 Select Crank pin bearing P NOTE ________________________________ The numbers indicate crankshaft jour nal sizes are stamped on the crankweb as shown in the illustration The numbers are stamped in ink on the connecting rod and connecting rod cap as shown in the illustration Selection of crank pin bearings If P on the connecting rod is 4 and P on the crankweb is 2 then the bearing size for P is Bearing size of P Connecting rod P Crankweb P 4 2 2 black 4 59

Скачать