Zyxel IES-5106 [1005/1156] Switch lldp enable command

Zyxel IES-5106 [1005/1156] Switch lldp enable command
Chapter 35 switch Commands
Management Switch Card User’s Guide
1005
35.9 switch lldp Commands
Use the switch lldp commands to configure and view LLDP (Link Layer Discovery Protocol)
settings. LLDP allows a network device to advertise its identity and capabilities on the local
network. It also allows the device to maintain and store information from adjacent devices which
are directly connected to the network device. This helps an administrator discover network changes
and perform necessary network reconfiguration and management. The device information is
encapsulated in the LLDPDUs (LLDP data units) in the form of TLV (Type, Length, Value). Device
information carried in the received LLDPDUs is stored in the standard MIB.
35.9.1 switch lldp enable Command
Syntax:
switch lldp enable
This command has the MSC use LLDP to send and get information about devices connected to its
interfaces. An example is shown next.
35.9.2 switch lldp disable Command
Syntax:
switch lldp disable
This command has the MSC not use LLDP to send and get information about devices connected to
its interfaces. An example is shown next.
35.9.3 switch lldp txinterval Command
Syntax:
switch lldp txinterval <sec>
This command sets the advertised interval (in seconds) the MSC waits before sending LLDP frames.
The following example sets the interval to 10 seconds.
35.9.4 switch lldp txhold Command
Syntax:
switch lldp txhold <cycles>
ras> switch lldp enable
ras> switch lldp disable
ras> switch lldp txinterval 10

Содержание

Скачать